Oz-Post Drivers, Spacers and other tools
Oz-Hammer - Driver for Jackhammer:
Oz-Hammers are REQUIRED for customers that want to drive the Oz-Posts in the ground with a jackhammer. Some Oz-Posts require Hammer-Spacers to be used in conjunction with this driver. Please see the list below or the Oz-Post product specifications.
Our exclusive Oz-Post driver is a high grade steel attachment that fits most common jackhammers that are available today. If you are planning to rent a jackhammer most rental centers have Bosch® Brute or Wacker® 60# electric jackhammers that are perfect for any size job. There are also gas powered jackhammers (Wacker® model BH-23 is one popular brand) that are great for remote locations where power cords or generators would have difficulty reaching. Air operated jackhammers also work, but is not recommended because they are very heavy and much more difficult to handle. There are many other jackhammer brands and most of them will do the job. Ask the rental center to clarify that the jackhammer has a 1 1/8” hex chisel holder with a retaining collar.
Be sure to check out our own line of Jackhammers like the EL-1000 and GP-1200
. They are specifically designed for driving Oz-Posts. Specifications: 1 1/8” hex chisel holder with a retaining collar. For use with (no Hammer-Spacer™ required): ISW-850, IS-600, I2-850, I2-600, Hammer-Spacers required for Oz-Post Models: I25-850, I3-850, T4-850, T4-600, P4-850, P5-850, T46-850, S4-850, S4-600 and T6-850.
Cap Driving Tool:
The Cap Driving Tool
is used to secure the compression collar to the Oz-Post on all round post models. (ISW-850, IS-600, GB-700 and HB-700) This tool is a hinged steel tube that makes installing the compression collar a snap. This tools is highly recommended when installing more than a couple cases of round Oz-Posts.
The Oz-Post Post Level
is a two way level that can be strapped on to the Oz-Post with a rubber band to keep it in place. This is helpful for making sure that you are driving the post in straight and plumb.
is simply a square piece of steel that slides over the Oz-Hammer (OH-01)
and keeps it centered on the inside of the Oz-Post sleeve when installing the T4-600, T4-850, C4-850, S4-850 and S4-600. This Hammer Spacer is used in conjunction with the OH-01 Oz-Hammer. The OH-01 Oz-Hammer is 2” in diameter. The T4-850 and other models mentioned above are a minimum of 3 ½” inside diameter so we recommend using the HSP-T4 to keep the Oz-Hammer (OH-01) centered in the Oz-Post sleeve during installation.