Installation is Easy!

Jerith Aluminum Fences are installed by setting a post in concrete and sliding the horizontal rails of a section into pre-punched holes in the post. A second post is then set at the other end of this section. A second section slides into the second post, and so on. This method of attachment is more secure than other means of mechanically fastening the section to the post using brackets or clamps. The fence sections are shipped fully assembled from our factory in 6 foot nominal lengths for easy installation. Smaller sections are simply cut to size on the job site.

Because these fences are screwed together, they can easily rake to follow the contour of the ground. A standard fence section will drop one foot over its six foot length. If a greater slope is involved, sections can be specially fabricated to traverse a 45 degree angle.

Click on any of the links below to download the Jerith Fence Installation Manuals.
( Adobe Acrobat Reader required - click here to get Acrobat - it's free!)

Previous Page